Bambu Lab P1S: Revision history

12 October 2024

• curprev 21:5721:57, 12 October 2024‎ Seto talk contribs‎ 7,079 bytes +143‎ Info über vorinstallierten OrcaSlicer Tag: Visual edit

17 September 2024

• curprev 21:5321:53, 17 September 2024‎ S3lph talk contribs‎ 6,936 bytes +3‎ →‎Filament entnehmen
• curprev 21:5321:53, 17 September 2024‎ S3lph talk contribs‎ m 6,933 bytes +3‎ →‎Filament einlegen

15 September 2024

• curprev 15:4515:45, 15 September 2024‎ S3lph talk contribs‎ 6,930 bytes −1‎ →‎Filament entnehmen
• curprev 15:4515:45, 15 September 2024‎ S3lph talk contribs‎ 6,931 bytes −18‎ →‎Troubleshooting
• curprev 15:4415:44, 15 September 2024‎ S3lph talk contribs‎ 6,949 bytes +2,335‎ →‎Druck-Vorbereitung
• curprev 15:2415:24, 15 September 2024‎ S3lph talk contribs‎ 4,614 bytes +70‎ →‎Bedienung
• curprev 15:0915:09, 15 September 2024‎ S3lph talk contribs‎ 4,544 bytes +2,987‎ No edit summary
• curprev 13:3813:38, 15 September 2024‎ S3lph talk contribs‎ m 1,557 bytes +60‎ →‎Drucker-Einrichtung

12 September 2024

• curprev 23:3323:33, 12 September 2024‎ S3lph talk contribs‎ 1,497 bytes +1,497‎ Created page with "{{Verwendung/Dokumentiert|s3lph,val}} == Kurzinfo == * Filamentdrucker * 1.75mm Filament * 1 Extruder * Automatischer Filamentwechsler mit bis zu 4 Filamenten * Empfohlene Slicer: ** Bambu Studio ** Orca Slicer (Fork von Bambu Studio mit mehr Tuning-Optionen) == Bedienung == Im folgenden wird die grundlegende Bedienung mit Bambu Studio erklärt, grundsätzlich kann aber jede Slicer-Software verwendet werden. === Installation von Bambu Studio === Bambu Studio kann a..."